Updating heating from radiators adult singles dating woodbine iowa

Make sure you add a mixing valve to the water heading out to your taps if you use the open direct system for hot water baseboard or radiator heating systems.

A mixing valve is simply a device (that you connect your domestic hot water supply to fixtures and your cold water supply) that mixes cold water into your domestic hot water to lower the temperature to prevent burns at your taps or shower.

The greatest advance in home heating in the past few decades has to be the Open Direct System invented by Radiantec.

updating heating from radiators-40

In the heating season, the cold water will be warm by the time it reaches the hot water heater.

This doesn’t really save money as you have already heated that water with your Polaris water heater/boiler.

The water is replaced by going from the cold water piping, through the circulating pump(s), through the zone and back to the hot water heater.

By the time this cold water reaches the hot water heater, it has already been preheated by the floor.

Although this system works awesome in the winter, the real energy savings are in the summer as all the water entering your water heater has to go through the floor first.

The cold water leaves your well (or municipal system) goes through all the zones of your heating system and is warmed/pre-heated.

By the way we have never had any condensation build-up on any concrete, wood, ceramic tile or click flooring that is being used to pre-heat the water.

The cold water will always flow through your floor first because of the check valve in the system.

If you are planning on installing a solar water heating system, the open direct is the perfect companion. Every BTU collected with solar, will cut your fuel consumption.

It is just a matter of plumbing in a new loop for the solar collectors if you live in a no freeze zone.

This will heat your floor effectively and is pretty normal.

Tags: , ,